3.3 Calculating the iRSS
3.3.0 Objective
3.3.1 Interfering Links
The characteristics of the interefering system summarised in Table 7 should be entered into the S...
3.3.2 System to be an interferer
Contrary to the victim link, is possible to set more than one interfering link in your simulation...
3.3.3 Transmitter
Set now the victim link transmitter by selecting the transmitter tab: the Interefering link tra...
3.3.4 Receiver
For this exercise, the Power Control is not activated, therefore there is no need to fill in any ...
3.3.5 Positioning of the ILT vs ILR
Positioning of the ILT vs ILR is similar to positioning VLT vs VLR as described in Section 3.2.5....
3.3.6 Positioning of the VLR vs ILT
SEAMCAT allows defining the relative location between the Victim link receiver and the Intereferi...
3.3.7 Calculating the iRSS by hand
Figure 91: Illustration of SEAMCAT display (only 1 snapshot) of the various pair of transmitter ...
3.3.8 Emission, reference, VLR bandwidth relationship and bandwidth correction factor
The proposed exercise considers the case where the VLR bandwidth is the same as the emission band...