Recently Updated Pages
4.4 iRSSoverlaoding
The following graphics presents the input parameters to activate when the overloading mechanism i...
4.3 iRSSintermodulation
The following graphics presents the input parameters to activate when the intermodulation mechani...
4.2.3 Protection ratio
This mode is identical to the “sensitivity” mode since the only difference is that the Blocking v...
4.2.2 Sensitivity mode
In this calculation mode the function blockMax Interf Signal (Df) that you entered represents the...
4.2.1 User-defined mode
In this case, the Blocking is provided in dB and represents the attenuation of the receiver at a ...
Intro
For this exercise, the blocking response from the receiver has a positive sign as shown in Figure...
4.1 iRSSunwanted
The following parameters should be changed in the simulation: (i) the interferer operates at 1000...
3.6.3 Example of probability of interference calculation
The protection criteria to be used for the calculation of the probability of interference and the...
3.6.2 Translation calculation mode
When the Translation mode is chosen, it is possible to calculate and display a chart of the proba...
3.6.1 Compatibility calculation mode
It is then possible to derive the C/I (i.e. dRSS/iRSS equivalent to dRSS-iRSS in dB): dRSS/iRSS =...
Objective
After the simulation of all events has completed, SEAMCAT will have calculated and ...
3.5 Extract results vectors (dRSS, iRSS etc...)
You can extract the dRSS vectors from the “Results” panel in the newly create workspace results i...
3.4 Launching a simulation
A simulation is now ready to be launched. It should be noted that prior to beginning the simulati...
3.3.8 Emission, reference, VLR bandwidth relationship and bandwidth correction factor
The proposed exercise considers the case where the VLR bandwidth is the same as the emission band...
3.3.7 Calculating the iRSS by hand
Figure 91: Illustration of SEAMCAT display (only 1 snapshot) of the various pair of transmitter ...
3.3.6 Positioning of the VLR vs ILT
SEAMCAT allows defining the relative location between the Victim link receiver and the Intereferi...
3.3.5 Positioning of the ILT vs ILR
Positioning of the ILT vs ILR is similar to positioning VLT vs VLR as described in Section 3.2.5....
3.3.4 Receiver
For this exercise, the Power Control is not activated, therefore there is no need to fill in any ...
3.3.3 Transmitter
Set now the victim link transmitter by selecting the transmitter tab: the Interefering link tra...
3.3.2 System to be an interferer
Contrary to the victim link, is possible to set more than one interfering link in your simulation...