Recently Updated Pages
Introduction
When simulating CDMA or OFDMA systems, you will have access to the additional tab "Cellular struc...
12.7 EPP results
In case an EPP is used and it returns a set of result, they will also be included next to the sta...
12.6 OFDMA output results
The results of the OFDMA simulation are given in terms throughput loss of the OFDMA victim. Figur...
12.5.3 CDMA results for cell selection algorithm
When the CDMA “cell selection” algorithm is simulated, the following output vectors are also avai...
12.5.2 CDMA results
Once SEAMCAT has completed the simulation, the results are shown as displayed in Figure 261, when...
12.5.1 CDMA capacity finding
During the pre-simulation part, the system estimates the load of the network as shown in Figure 2...
12.4.6 Average active WSDs per frequency vector
It provides the average number of active WSD per event for a specific frequency: ...
12.4.5 Average e.i.r.p. per frequency
It presents the average e.i.r.p. per event (dBm vs MHz) for all the active WSDs transmitting at a...
12.4.4 Victim frequency vector
The victim frequency vector (MHz) represents the frequency at which the victim device transmits p...
12.4.3 WSD e.i.r.p.
The actual selected e.i.r.p. (dBm) at which the WSDs are allowed to transmit as the result of the...
12.4.2 WSD frequency
This vector represents the actual selected frequency (MHz) at which the WSDs are allowed to trans...
12.4.1 sRSS vector
The sRSS vector (dBm) is merely the sRSS value calculated at the selected WSD frequency (i.e. whe...
Introduction
When the cognitive radio mode is activated, SEAMCAT resturns the output vector shown in Figure 25...
12.3.4 Overloading results
As a result of the equation described in Annex A5.4, for each event and at each frequency, the su...
12.3.3 Intermodulation results
iRSS intermodulation folder (Figure 248) with as many iRSSintermod vector for each combinatory co...
12.3.2 Calculated radius
The calculated radius folder contains the values of the coverage and/or simulation radii calculat...
12.3.1 Generated signals results
dRSS folder (ANNEX 4:) with dRSS vector; iRSS unwanted folder (ANNEX 5:) with as many iRSSu...
Introduction
After running a simulation with generic system, each of these signals is displayed with indicated...
12.2 Overview of output results
Table 51: Interference criteria summary for various victim systems Victim system Intere...
12.1.4 Cellular system outline
Once SEAMCAT has determined the number of UEs per cell either through simulation of optimal capac...