Recently Updated Pages
10.4.4 Adjacent channel scenario - e.i.r.p. max. in-block limit
In the case where the WSDs are not allowed to transmit in the same operating frequency as for the...
10.4.3 Probability of failure
This feature is input selectable (by default, it is de-activated).The probability of failure may ...
10.4.2 Detection of threshold
In relation to the spectrum sensing results, if this CR detect that a victim system is in the vic...
10.4.1 Spectrum sensing characteristics
When the spectrum sensing is activated, the tab “Interfering link transmitter to victim link tran...
10.3.5 Propagation Model
You can choose the suitable propagation model to be applied when calculating signal loss between ...
10.3.4 Pathloss correlation
The panel is activated if the victim is either OFDMA UL or OFDMA DL. It is decribed in more detai...
10.3.3 Interferers density
The panel is activated if "Uniform density" or/and "closest interferer" mode is selected. See Ann...
10.3.2 Relative positioning of interfering link (Cellular system)
The relative position of the Victim Receiver (VLR) and the Interfering cellular system depends on...
10.3.1 Relative positioning of interfering link (Generic system)
The relative position of the Victim Receiver (VLR) and the Interfering Transmitter (ILT) depends ...
introduction
The ILT to VLR path can have several combinations as shown in Figure 224. Four panels characteris...
10.2.3 Generation of interferers with the same characteristics
Within one interfering link, you can define a number of active interfering transmitters when the ...
10.2.2 Auto-generation of multiple interfering links
This option corresponds to duplicate n times a specific interfering links on a circle or on a hex...
10.2.1 Generation of multiple interferer links with different systems
This option allows SEAMCAT to generate multiple interferers which may have the same or different ...
10.1 Setting the scenario
A typical scenario consists of one victim link which describes the communication system being in...
RESULTS
The results tab for the case of IMT-2020 as a victim system and the produced outputs are similar ...
LINK-TO-SYSTEM LEVEL MAPPING
A look up table is used to map throughput in terms of spectral efficiency (bps per Hz) with respe...
POSITIONING
In Section 7.5. of this Handbook it is explained cellular network positioning of BSs and MSs whic...
Beamforming Subarray Active Antenna Systems
Active Antenna System Active Antenna System are described in Recommendation ITU-R M.2101 and the ...
BEAMFORMING ANTENNAS IN IMT-2020 SYSTEMS
Introduction A key. feature of IMT-2020 systems are beamforming array antennas which use phase sh...
ALGORITHM DESCRIPTION
The simulation algorithm is implemented according to the specification outlined in Rec. ITU-R M.2...