Recently Updated Pages
5.3.3 Transmitter antenna pointing
This is the same panel as in section 5.2.1 so that transmitter characteristics can be imported/ex...
5.3.2 Transmitter power
In SEAMCAT, the transmitter power (P) is expressed as conducted power in dBm, including feeder lo...
5.3.1 Transmitter identification
This is the same panel as in section 5.2.1 so that transmitter characteristics can be imported/ex...
Introduction
It can be the ILT or the VLT as illustrated in Figure 146. Figure 146: Transmitter illustratio...
5.2.5 Interference criteria
Section 1.4 presented the concept of interference criteria (C/I, C/(N+I), (N+I)/N, I/N) when the ...
5.2.4 Reception characteristics
This panel consists in setting of the receiver characteristics of the generic system: Table 12:...
5.2.3 Antenna patterns identification
This panel is a common interface that is reused in all other radio system. It contains all inform...
5.2.2 Antenna pointing
This panel is a common interface that is reused in other radio system. It contains all informatio...
5.2.1 Receiver identification
This panel is a common interface that is reused in all other radio system. Table 9: Receiver id...
Introduction
It can be the VLR or the ILR as illustrated in Figure 143. Figure 143: Receiver ill...
5.1.2 General
The user can enter the frequency. The frequency value is overwritten at the “Scenario” tab level....
5.1.1 System
You can name and write some description of the victim system you want to simulate.
Intro
This tab allows you to update all scenario parameters of for a generic system . In the upper part...
4.10 Antenna gain
For simplification, we consider that the Victim link receiver and the Interfering link transmitte...
4.9 Power Control
Note: The power control is used only in this section. When considering other sections, the power ...
4.8 Protection distance
If a minimum protection distance between the victim link receiver and interfering link transmitt...
4.7.2 "None" mode
When you select the “None” mode (see ANNEX 13:), he can also define a Uniform density of terminal...
4.7.1 Uniform density mode - simulation radius calculation
The number of active transmitters that will be uniformly located within the simulation radius is...
4.6 Simulation radius (ILT-VLR)
The distance between the Victim link receiver and the Interfering link transmitter is referred to...
4.5 Coverage radius (VLR-VLT)
In this section the Free Space Model is used to derive the attenuation on the different paths and...